|
|||||||||||
 |
|||||||||||
|
|||||||||||
|
|||||||||||
| You are here: Home » Solutions for users » The room system in detail | |||
Height adjustment + wall fixture |
|||
| Height adjustment with profile connectors During pre-assembly insert the profile connnectors into the suppporting profile up to 10 mm and tighten with system screws. Adjustment - 10 mm to + 30 mm possible. |
 |
||
| Height adjustment with elevating insert For use of load-bearing joint profiles with holes. Profile connectors are fully pushed into the supporting profiles and tightened during pre-assembly. The elevating inserts (screw 8x50 and slot nut) are used next to the supporting profile. The joint profile must make contact with the floor profile. |
 |
||
| Wall fixing with 3D fittings Pre-assembly of the 3D fasteners in the cross-slots of the supporting profiles. M8 nut and washer at same height (= supporting profile length). Distance approx.896 mm. Dowel fixing to the wall through the slots on the base plate. (through fixing). Washer required under screw head! With very uneven walls use underlying base plate. Fine adjustment in wall direction 10 mm max. - Release nut - Adjust the collar screw to the right depth with a screwdriver - Retighten the nut Max. lateral adjustment in the supporting profile slot 12 mm. - Release nut - Shift profile - Retighten the nut Height adjustment 12 mm. - Release the wall fixture screws - Adjust the height - Retighten the screws Wall spacer is supplied without adjustment insert and must be equipped with a (M8) threaded bolt of the required length. |
  |
||
|
|||
| Further information "The room system in detail" | |||
| Further information | |||
|
|||
| © 2004-2006 Kusanke Beschlagtechnik. All rights reserved. | back
to top 
|